Drywall Installation in Colorado

Hanging is where a good finish is won or lost. Sheets that run the wrong way, joints landing on a stud that is bowed, screws set too deep, butt joints stacked in the middle of a long wall — every one of those is a problem the taper inherits and the paint shows.

We hang basements, garages, additions, and whole houses, and we lay the sheets out before the first screw so the joints land where they should and where the eye will not group them.

What's included

Basements, garages, additions and whole houses
Ceilings hung first so the walls carry the edge
Sheets laid out so joints do not stack where the eye groups them
Screws set to dimple, not through the paper
Cuts kept out of door and window corners, where cracks start

Ceilings go up before walls, so the wall sheets hold the ceiling edge instead of the tape carrying it alone. Screws are set to dimple, not to break the paper, because a screw that tears the face has nothing left to hold and telegraphs later as a line of small pops.

Around the openings, the board is cut so the seam does not run out of a door or window corner, which is where a house moves most and where cracks start. In a garage we take the ceiling and walls together, since that is usually where the fire separation matters and where a half-finished job is most obvious.

How we work

Walk the space

We measure and look at the framing. Bowed studs and out-of-plane corners are cheaper to deal with before the board goes on than after.

Lay out the sheets

Where the joints land is decided before anything is screwed, so butt joints do not stack in the middle of a long wall.

Hang ceilings, then walls

In that order, every time. It is what keeps the ceiling edge supported instead of hanging on tape.

Finish or hand off

We tape and texture the same job if you want it, or leave it hung and screwed off clean for whoever is finishing.

Common questions

Can you do the whole basement, not just the drywall?

We hang, tape, texture and paint. Framing, electrical and plumbing are separate trades — tell us what your job needs and we will say plainly what we do and what has to go to somebody else.

Do you take small jobs, like one room?

Yes. One room, one garage, one closet under the stairs. The truck says patch on the door for a reason — small work is normal work here, not a favour.

How long does a garage take?

It depends on the size, the ceiling height and whether it is being finished or just hung. We will give you a number when we see it, and we would rather give you a real one than a fast one.